Oscillating wall-mounted air blower, high performance 75 Cm, 180 Watts with remote control

Lba Home

the WallTurbine Wind Turbine guaranteed for 2 years

WallTurbine Wall-mounted air blower 75 Cm 180 Watts  and oscillating control.

WallTurbine is one of the most powerful stand-mounted brewers on the market, it has a quality that is difficult to find elsewhere, it is oscillating and wall-mounted. This is an important quality because it allows a very wide ventilation of a workshop or warehouse.

When we think of fan we think of classic fans. But when you have large rooms to ventilate, or just a warehouse or workshop, classic fans are clearly inoperative.

Indeed a classic fan is not made to run continuously and at maximum speed.

So the solution lies in the air blowers, but what are the differences between these blowers and our classic fans? Many, let's review the important points.

1) The differences in ventilation capacities.

Specifically this point is one of the most important between the two types of fans, a classic fan "pushes" the air without rotating it, the air flow behaves like a wall moving forward. 

An air blower creates a mini "vortex" or small tornado allowing the airflow to be more concentrated. 

To do this test, take a balloon, put the head of your fan horizontally, and put the balloon in the center of the grid, turn on the fan. 

In one case, the fan will fly away as if pushed by the wind, in the case of the brewer, the balloon will remain suspended in the center of the vortex. 

2) The noise level.

Unquestionably, a fan fan is a fan to be reserved for more commercial use, because it is very noisy, the blades emit bass like the blades of an airplane. If you want to ventilate a garage or other uninhabited rooms, it will be appropriate, in the case of a living room, a bedroom, in short a living room, forget the Brasseur d'air and switch to a classic fan.

3) Consumption and motors.

The classic fans, "cheap" are ALL made in Asia and 90% in China. The motors are 40 to 60 Watts and the current standard does not require motor efficiency (ratio of watts consumed / airflow). 

In addition, for the last ten years or so, motors are no longer made of copper but of aluminium, it is cheaper than copper (that's obvious), but aluminium can withstand heat less well than copper, motors are much more fragile. 

The motors of the brewers when a them, for two years, are governed by a very restrictive standard, obliging the manufacturers to respect a ratio watt/airflow.

The brewers have more powerful motors, from 60 to 120 Watts and even more for brewers from 60 to 80 Cm.

The problem is the same as with the traditional fans, the private brands (type le__oy Me__in or Ca______ma) run after the price, have aluminum motors that do not hold in continuous operation. 

So obviously WallTurbine, requires 100% copper motors.

4) the structure of the fans.

Conventional fans are often made of ABS, with 1 mm honeycomb protection grids. The blades are made of plastic, the arms and feet are often "light" metal.  

The air blowers, on the other hand, are made of metal, the blades are metallic, the grids are welded, and are made of "metal wires" of 2 to 3 mm according to the models.  

The paints used are oven paints to avoid corrosion as much as possible. 

The weights have no comparison, a 40 cm standing fan weighs on average 3 to 4 Kg, a stirrer from 6 to 8 Kg.

With these differences, you can deduce that brewers are to be reserved for specific uses in places where nuisance is not a problem.

The LBA HOME brewers are designed for professionals, and they are the all-terrain brewers of ventilation. For LBA HOME the quality is only seen in time or in the use in complicated environments, sand, dust, smoke etc...

Finally, this version is equipped with a variator on remote wire, the power cable is 1.5 meter, it will be easy for you to add cable to offset the variator of the length you want. 

Configuration delivered as follows:

Technical data :

Power: 180 Watts 220/~50 (V/Hz)

Grid diameter: 75 Cm

Blade diameter: 70 Cm

Number of speeds : 3 with remote control, on 1.5 meters wire.

Air flow rate : 11890 M3/h

Rotation speed: 1050 Rpm

Finish: Galvanized steel blades, black grille, black wall bracket.

Grid: 40° adjustable horizontal movement, 80° oscillation.

Total height: from 80 Cm  

Connection: Wall

Weight : 9 Kg

Standards: EN 60335-2-80 - DIN EN 294

Warranty: 2 years